![]() ![]() I followed your suggestions and found a Netgear FA-310TX (revision D1) NIC and this was at least able to get an IP address. ![]() ![]() I was able to get CentOS 4.4 installed and them updated. I beat my head against the wall trying to get forcedeth to work during installation, but never could. You can even start a PXE installation with the onboard forcedeth NIC, but the NIC will not "activate" at the step where you select dhcp or static. Oddly enough, on the nvidia-based systems I have installed CentOS4 on, you can open one of the installation consoles and see that the forcedeth module gets loaded, but the NIC doesnt activate. The RTL-8169 should be supported by the CentOS4 installer (or at least an RTL-8169S-32-based card I tried is supported). Be sure to answer the kudzu questions each time. You can turn the other NIC (eth1) on during the next boot. If you have a preference for eth0, only turn that NIC on and boot. The realtek and nvidia NICs should work fine after the CentOS4 installation. During each boot, you will be prompted by kudzu to remove/configure the NICs. Then boot once without a NIC followed by turning on the onboard NICs in BIOS. Turn off the onboard NICs in BIOS, temporarily install the installer-supported NIC, do the CentOS4 installation and then remove the NIC after you have finished firstboot. I keep several Marvell 88E8001-based NICs (i.e., sk98lin or skge, depending on kernel/distro) for troubled installations. Install an installer-supported NIC and do the CentOS4 installation. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |